Video Loss - Dahua 6064 SERIES User Manual

Parameter
Record Delay
Alarm out
Latch
Show
message
Buzzer
Alarm upload
Message
Send Email
Tour
PTZ
Activation
Snapshot

4.8.3.1.2 Video Loss

From main window->Setup->Event->Video detect->Video loss, the video loss interface is shown as in
Figure 4-55.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest setups, please refer
to chapter 4.8.3.1.1 motion detect for detailed information.
Function
period and go to Storage-> Schedule to set current channel as
schedule record.
System can delay the record for specified time after alarm ended.
The value ranges from 10s to 300s.
Enable alarm activation function. You need to select alarm output
port so that system can activate corresponding alarm device when
an alarm occurs.
System can delay the alarm output for specified time after an
alarm ended. The value ranges from 1s to 300s.
System can pop up a message to alarm you in the local host
screen if you enabled this function.
Check the box here to enable this function. The buzzer beeps
when an alarm occurs.
System can upload the alarm signal to the centre (Including alarm
centre.
When 3G network connection is OK, system can send out a
message when motion detect occurs.
If you enabled this function, System can send out an email to alert
you when an alarm occurs.
You need to click setup button to select tour channel. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs. See Figure
4-53.
Here you can set PTZ movement when an alarm occurs. Such as
go to preset X. See Figure 4-52.
Click setup button to select snapshot channel. See Figure 4-54.
164