Welcome Thank you for purchasing our NVR! This quick start guide will help you become familiar with our NVR in a very short time. Before installation and operation, please read the following safeguard and warning carefully! Important Safeguard and Warning ...
4. Turn the device upside down 6. Connect the HDD cable and Fix the HDD firmly. and then turn the screws in power cable. firmly. in the chassis. 7. Put the cover in accordance 8. Secure the screws in the with the clip and then place the rear panel and the side panel.
The rear panel is shown as in Figure 2 (Picture for reference only). Figure 2 Please refer to the following sheet for detailed information. Port Name Connection Function USB2.0 port. Connect to mouse, USB storage USB2.0 port device, USB burner and etc. 10M/100Mbps self-adaptive Ethernet port.
Page 5
Figure 3 7. Smart Add When the network camera(s) and the NVR are in the same router or switch, you can use smart add function to add all network cameras to the NVR at the same time. There are two ways for you to go to the smart add interface. From the startup wizard, click Smart add button.
Page 6
Figure 5 Note This quick start guide is for reference only. Slight difference may be found in the user interface. All the designs and software here are subject to change without prior written notice. All trademarks and registered trademarks mentioned are the properties of their respective owners.
Need help?
Do you have a question about the NVR2104-S2 and is the answer not in the manual?
Questions and answers