Ptz; Ptz Settings - Dahua 6064 SERIES User Manual

steps listed below.
From Main menu->Setting->System->Display->Tour, you can see an interface shown as in Figure 3-27.
Here you can set tour parameter.

Screen No.: Please select screen from the dropdown list.

Video detect: It is to set video detect tour. System supports 1/8-window tour.

Alarm: It is to set alarm tour. System supports 1/8-window tour.

Enable tour: Check the box here to enable tour function.

Interval: Input proper interval value here. The value ranges from 1-120 seconds.

Window split: It is to set window split mode.
Tips
On the navigation bar, click
Click Save button to save current setup.

3.6 PTZ

Note:
Before you control the PTZ, please make sure the PTZ decoder and the NVR network
connection is OK and the corresponding settings are right.

3.6.1 PTZ Settings

Cable Connection
Please follow the procedures below to go on cable connection

Connect the dome RS485 port to NVR RS485 port.

Connect dome video output cable to NVR video input port.

Connect power adapter to the dome.
Figure 3-27
/ to enable/disable tour.
41