Connection - Eneo VK-1318/WDDG1 Installation And Operating Instructions Manual

Note
B
Screw holes
W
Back of housing
Note
G
Housing cap
Connection cable
K
Cable feed
5. Connection Assignment
a) The cables should be assigned as follows for the ‚eneo camera package' which is supplied with a connection cable
with open ends:
Model
Video output
V earth
Power supply
Note
Comments
b) The following connectors are mounted on the „eneo camera packages", which are supplied with system cables
(video/DC):
Model
Video output
Power supply
A)
The operational side of the camera is mounted in the housing.
Prepare the mounting site for installation.
Loosen the 4 Torx screws on the housing, but do not completely remove them,
and remove the cap.
Mark the position of the back of the housing W on the surface on which the
device is to be mounted. The screw holes B in the back of the housing W may
be used as a template.
Fix the back of the housing W on the desired surface (plug and cross-head
screws are enclosed) and feed through the cable. 1/3" or 1/2" opening.
When mounting on a ceiling, the camera must be installed within the housing.
Fasten housing cap G on the back of the housing.
After connecting the power supply and attaching the coaxial cable to an
appropriate monitor, the camera is operational.
1/3" and 1/2" socket. The 1/2" high-strength cable gland is included in the
accessories. A dummy plug for the 1/3" socket is included.
VK-1318/WDDG1/2, VKC-1413WDDG1/2,
VKC-144/WDDG1/2
white/yellow
black
red
Take note of the signal and voltage polarity !
The multi-wire connector cable with EDP No. 70226 is recommended for the
„eneo camera packages", which are supplied with a connection cable with open ends.
VK-1320WDDG1/2, VKC-1414/WDDG1/2,
VKC-1324WDDG1/2, VKC-1326WDDG1/2
A) Stereo jack connector (black)
BNC jack (white)
B) Adapter bushing (green), for 12VDC/24VAC
16
VKC-148/WDDG1/2
white
screen
white/yellow
VKC-1327
B)