Device Connection; Connection To Pc; Connection To Router/Switch - Eneo INP-7 Series User Manual

2 Device Connection

The Speed dome can be connected in two ways:

2.1 Connection to PC

Connect the speed dome to PC via straight-through network cable, with power input connected to a DC
12V adaptor, and set the IP addresses of the PC and the dome in the same network segment. The dome will
communicate with PC within one minute after being powered on if the network operates normally.

2.2 Connection to router/switch

This is more commonly used in connecting a speed dome to Internet, where the dome and PC are
connected to LAN ports of a router/switch, with gateway of the dome set to the IP address of the router.
6
USER MANUAL