Gas Connection; Adaptation To Varius Types Of Gas - Caple C895IBK Instruction Manual

Gas connection (Fig. 8)
Connect the appliance to the gas cylinder or to the installation according to the prescribed standards
in force, and ensure beforehand, that the appliance matches the type of gas available. Other wise, see
"Adaptation to various types of gas". Further more, check that the feed pressure fall swithin the values
described on the table: "User chacteristics".
GB
Rigid/semi rigid metalconnection
Carry out the connection with fittings and metal pipes (even flexible pipes) so as to obtain counter
stress the inner parts of the appliance.
N.B. - when the installation has been carried out, check the perfect sealing of the entire connection
system, by using a soapy solution.
Adaptation to varius types of gas (Fig. 9)
Should the appliance be pre-set for a different type of gas than available, procreed as follows:
• replace the injector (Fig. 9) with the corresponding type of gas to be used (see table "User
characteristics");
• to adjust to the minimum, use a screwdriver on the screw placed on the tap (Fig. 10) after turning the
tap to its minimum position. For GPL (butane/propane) screw tight.
Fig. 8
B
A
Fig. 9
16