Functions - Caple C895IBK Instruction Manual

Functions

Switching the Touch control ON/OFF
After mains voltage is applied the control initialises for approx. 2.5-5 seconds before it is ready for
operation. After a reset all displays and LEDs glow for approx. 1 second. When this time is over all
displays and LEDs extinguish and the control is in the stand-by mode.
By operating the ON/OFF key the control can be turned into the ON-mode. The cooking zone displays
GB
show a static "0".
If a cooking zone is in the "hot" status, the display shows alternating "H" and "0". The bottom right dot is
blinking in 1 second intervals on all cooking zone displays to indicate that no cooking zone is selected
at the moment.
After switching-ON the electronic control remains activated for 20 seconds. If no cooking zone or timer
selection follows within this period of time, the electronic control automatically switches back into the
stand-by-mode.
The control can only be switched-ON if it identifies the ON/OFF key alone being operated. Should it
recognize key activation other tham that, the control remains in the stand-by-mode.
If the child safety feature is active when switching on, all cooking zones show "L". (LOCKED). (also
refer to 1.11). If the cooking zones are in a "hot" status, the displays shows "L" and "H" in alternation.
Then the Touch Control is ON it can be switched-OFF at any time by operating the ON/OFF key. This is
also valid if the control has been locked (activeted child safety feature).
The ON/OFF key has always priority in the switch-OFF function.
Automatic switch-OFF
When the control is ON it automatically switches-OFF after 20 seconds if no cooking zone or select
key has been operated within this period of time. If case of a cooking zone selection, the automatic
switch-OFF time is composed of 10 seconds deselection time for a cooking zone at setting "0" and 10
seconds switch-OFF time.
Switching a cooking zone ON and OFF
If the control is ON the respective cooking zone can be selected by operating a cooking-zone-select-
key (=PLUS-key of the respective cooking zone).
There is a static dot indication in the respective display. If the cooking zone is hot "0" is displayed
instead of "H". On all other cooking zone displays the blinking dot extinguishes. Then a setting will
be chosen by a renewed operation of the cooking-zone-select-key or the MINUS-key and the cooking
zone begins to heat up. In order to use the cooking-zone-select-key as a PLUS-key the control has to
recognize that after the selection the cooking zone has been released for 0,3 seconds.
After selection of a cooking zone the setting can be increased by continously pressing the PLUS-key,
starting at step "1" it is increased by 1 step every 0,4 seconds. When setting "9" is reached the setting
will not be changed further (end stop).
If the selected cooking zone will be switched ON by means of the MINUS key, the cooking zone
starts at the maximum setting "9" ("reverse switching-ON"). When the key is continuosly operated, it
decreases by 1 step every 0,4 seconds. When setting "0" is reached, there will be no further setting
changed (end stop). Only a renewed operation of the MINUS (or PLUS) key changes the setting.
Switching OFF an individual cooking zone
To switch off an individual cooking zone, the respective cooking zone has to be selected with the
cooking-zone-select-key (=PLUS). The selection is indicated with the static dot in the respective
cooking zone display. If the control recognizes that the PLUS- (cooking-zone-select-key is the PLUS-
key) and the MINUS- key have been activated simultaneously the setting of the selected cooking zone
will be put back to "0".
Alternatively, the MINUS-key can be used to count down the setting to "0".
8