Gas Connection - Caple C886G Instruction Manual

G A S C O N N E C T I O N
The hob should be connected to the gas-supply by a Gas safe registered installer. During
installation of this product it is essential to fit an approved gas tap to isolate the appliance
from the supply for the convenience of any subsequent removal or servicing. Connection of
the appliance to the gas mains or liquid gas must be carried out in compliance with current
regulations, and only after it is ascertained that it is adaptable to the type of gas to be used. If
not, follow the instructions indicated in the paragraph headed "Adaptation to different gas types".
In the case of connection to liquid gas, by bottle/tank, use pressure regulators that conform to
current regulations in force.
I M P O R TA N T:
For safety, for the correct regulation of gas use and long life of the appliance, ensure that the gas
pressure conforms to the indications given in table 1 "Burners and injector specifications".
(Copper or steel)
- Connection to the gas source must be done in such a way as to not create any stress points at
any part of the appliance.
- The appliance is fitted with a 1/2" gas male 'L' shaped union and a gasket for the attachment to
the gas supply.
- Should this union have to be re-positioned, the gasket must be replaced.
16 Instruction manual C886G | C887G | C889G
Please keep this instruction manual for future reference
C O N N E C T I O N TO F L E X I B L E S T E E L T U B E
The gas feed connector to the appliance is a threaded, male 1/2" connector for round gas pipe.
Only use pipes and sealing gaskets that conforms to the standards currently in force. The maximum
length of the flexible pipes must not exceed 2000mm. Once the connection has been made,
ensure that the flexible metal tube does not touch any moving parts and is not crushed.
C H E C K T H E I N S TA L L AT I O N
Once the appliance has been installed, make sure all the connections are properly sealed, using
liquid detector fluid and a 'U' gauge. Never use a flame.
E L E C T R I C A L C O N N E C T I O N
(The hob is fitted with a standard 13A plug)
Fit the supply cable with a standard plug for the demand rate indicated on the rating plate or
connect it directly to the electrical mains. In the latter case, a single pole switch must be placed
between the appliance and the mains, with a minimum opening between the contacts of 3 mm in
compliance with current safety codes (the earth wire must not be interrupted by the switch). The
power supply cable must be positioned so that it does not reach a temperature in excess of 50~C
above room temperature at any point.
B E F O R E A C T U A L C O N N E C T I O N M A K E S U R E T H AT:
- The fuse and electrical system can withstand the load required by the appliance;
- That the electrical supply system is equipped with an efficient earth hook-up according to the
norms and regulations prescribed by law;
- That the plug or switch are easily accessible.
I M P O R TA N T:
The wires in the mains lead are coloured in accordance with the following code:
Green & Yellow Earth
Blue Neutral
Brown Live
Please keep this instruction manual for future reference
Instruction manual C886G | C887G | C889G 17