Pre-Operation - Craftsman ZT 7000 Operator's Manual

B
B
B
Read The Operator's
Manual
* Read the operator's manual.
You should always read and follow
the instructions in the operator's
manual. Proper care, performance tips, and safety
information is located in this important document.
Always Check the Oil
Level
o Check the engine oil bvel.
The engine in your tractor has been
shipped, from the factory, already
filbd with oil for use during the engine break-in period.
Always check the oil bvel before starting the engine.
Fill-Up with FRESH
Gasoline
o Fill the tank with fresh fuel.
The single most common service
issue is stale or contaminated fuel!
Fuel should not be more than 30 days old. Use fuel
stabilizer to extend the life of your fuel, and always
store fuel in an approved, sealed, plastic gas can.
Stab fuel clean-out is not covered under your war-
ranty.
%
one hour at 6-10
Charge The Battery
Lift the seat deck to access the
battery, if the unit is put into service
after the month and year indicated
on the battery date tag (located on
top of battery) charge the battery for
amps. Refer to the SERVICE &
ADJUSTMENTS section of the operator's manual for
battery charging information.
Check Tire Pressure
Reduce the tire pressures to the
pressures shown below. Tires are
over-inflated for shipping purposes,
and must be set to the correct pres°
sures for optimum traction.
Rear Tire Pressure: 10°12 PSi
Front Tire Pressure: 18o20 PSi
B
B
Push Unit Off Crate
To push the unit off the crate:
Set BOTH transmission
release levers to PUSH posi-
tion by pulling the levers back
(levers are located at the rear
of the rider).
Cut the steel banding securing rider to pallet (6
bands).
o Move the ground speed control levers in to
DRIVE positions.
Set the mower cutting height to its highest set-
ting.
o Fold the cardboard used to crate the unit in half,
and place it under the front wheels of the unit.
Push the unit forward off the crate.
o Set the transmission release valve levers back
to DRIVE positions (levers pushed in).
OFF
RUN
_START
Start The Engine
To start the engine:
• While sitting in the operator's
seat, place the ground speed
control levers in PARK (levers
out). Make sure the yellow
PTO switch is OFR
Move the engine throttle control fully forward to
FAST,
o Set the choke control to CLOSED
NOTE." A warm engine may not require choking. In
this case, set the choke control to OPEN.
o insert the key into the ignition switch and turn it
to START.
After the engine starts, gradually move the
choke control to OPEN position. Warm the
engine by running it for at bast a minute before
turning on the PTO switch, or driving the unit.
After warming the engine, ALWAYS operate
the unit with the throttb set to FAST position
when mowing.
o See the OPERATION section for driving infor-
mation.