Purge Reset; Purge Detergent Line - Malmet WDS Operation, Maintenance And Installation Manual

WDS
Operation, Maintenance and Installation Manual
Purging must only be undertaken by Malmet service personal of Malmet trained facility maintenance
personal.
5.5

PURGE RESET

1.
Turn power OFF
2. Turn power ON at control LCD display
3. Hold down both SCROLL
4. SCROLL to SERVICE menu and press SELECT
5. SCROLL to RESET menu and press SELECT
6. Press SELECT again to start Purge Reset cycle
When purge reset is completed the Display will resume normal operation

5.6 PURGE DETERGENT LINE

1.
Turn power OFF at control LCD display
2. Turn power ON at control LCD display
3. Hold down both SCROLL
4. SCROLL to TEST menu and press SELECT
5. SCROLL to DETERG menu and press SELECT
The detergent pump will run for 5 seconds, if detergent line completely purged display shows PASS; then DETERG
If display shows FAIL then DETERG repeat steps SELECT
To EXIT
1.
SCROLL to EXIT press SELECT
2. SCROLL to EXIT press SELECT
3. SCROLL to EXIT press SELECT
LCD display goes blank.
ISSUE 5
at control LCD display
and SELECT buttons, when MENU is displayed, release buttons.
and SELECT buttons, when MENU is displayed, release buttons.
Page
"Confirm" should then display
RELAY
START press SELECT
START; press SELECT
31
START/RUNNING.
15/03/2016