Malmet WDS Operation, Maintenance And Installation Manual page 17

WDS
Operation, Maintenance and Installation Manual
3.2.1 URINE BOTTLE ONLY LOADING AND OPERATING CYCLE
Refer to laminated WDS Instructions
Operating cycle
1. Open door, use
2. Select URINE / BEDPAN cycle press
3. Close door, use
When door closes the cycle will start automatically.
Cycles will be shown on LCD display
1. Cold water wash
2. Hot water wash with detergent
3. Hot water rinse
4. Disinfection
5. Cool down
6. Completed
When the cycle is completed the display will show COMPLETED OPEN DOOR
4. Open door, use
NOTE: If temperature inside the chamber is too high the display will flash, WAITING COOLING
When the temperature has dropped to a safe level the display will flash, OPEN DOOR
To open door, use
5. To run the same cycle repeat steps 1 to 3
6. If you don't need to run another cycle close door by pressing
NOTE:
When the cycle has started the operating cycle cannot be interrupted.
•
In an emergency, if the cycle needs to be stopped press the EMERGENCY CYCLE STOP button.
•
The display will show a Fault code 904 (See note below).
•
NOTE:
• If a FAULT code is displayed on LCD display contact the service engineer to rectify.
ISSUE 5
or press
or press
or press
or press
17
Page
15/03/2016