Maintenance; Bi Monthly - Malmet WDS Operation, Maintenance And Installation Manual

WDS
Operation, Maintenance and Installation Manual
Maintenance, preventative or breakdown, is to be completed by a qualified person. Failure to comply with this
may result in unsafe conditions.
The Malmet WDS is self-cleaning, however, proper care should be taken to ensure that the unit is cleaned and
maintained. In accordance with maintenance instructions for Malmet WDS, regulatory and common sense practices.
Preventative Maintenance Schedule
5.1 DAILY MAINTENANCE (Operator or Maintenance Technician)
a) Run the Bedpan urine cycle to bring the unit up to operating temperature and sanitize the internal wash chamber
area. (Do not load any items)
b) Wipe out the inside of the door and gasket with warm water and detergent. A wipe with disinfectant is also
desirable.
c) Wipe over outside stainless steel panels with a stainless steel cleaner. (Do not get cleaner into the opening of the
USB port )
d) Wipe the front control panel with a soft cloth and mild detergent as necessary. Care should be taken not to
damage the digital display or to activate a cycle. (Turn off power at control panel)
e) Check level in detergent bottle, replenish as necessary
5.2 BI-MONTHLY MAINTENANCE (Maintenance Technician)
a) Check for steam or water leaks. Tighten hose clamps where necessary.
b) Check flush nozzles for free rotation.
c) Remove level probe in steam generator tank and water tank, clean off any residue build up.
d) Remove temperature probes in steam generator and chamber and clean off any residue build up.
e) Visually inspect build-up of residue in steam tank, especially in locations with poor water quality.
f) Check filter in the water inlet solenoid valve and clean as necessary.
g) Check all electrical connections, and tighten if necessary.
Stainless Steel Maintenance/Care
Under normal usage, stainless steel products require regular cleaning with a soft clean rag moistened with a mild
detergent followed by a water moistened clean rag and then a dry rag.
The #4 satin finish steel should be protected against Muriatic acid and caustic or abrasive materials and harsh cleaning
detergents. In the event such agents cause discoloration, polish with a stainless steel cleaner such as 3M Stainless Steel
Cleaner & Polish and a pad.
ISSUE 5

5.0 MAINTENANCE

26
Page
15/03/2016