Fault Indication - Malmet WDS Operation, Maintenance And Installation Manual

WDS
Operation, Maintenance and Installation Manual
Second Warning
When no full segments are showing EMPTY DETERGENT is flashing
At this stage there is approximately 750mL to 1lt in bottle
Third warning
Fault 302 Detergent time out. No detergent in bottle
When full bottle is installed the detergent line will require purging (refer to page 31)
4.3

FAULT INDICATION

In the event of a Power failure or operation failure during cycle the device will go to fault. The display will show the
selected cycle the unit was operating in when power failed or operation failed. After fault has been rectified a Purge/Rest
will be required to start the device.
FLT XXX flashing
Audible Buzzer will beep
ISSUE 5
FAULT 302
FAULT 302
FAULT XXX
25
Page
15/03/2016