Electrical Installation - AEG 41102IU-MN User Manual

28 www.aeg.com
13.3 Levelling of the appliance
Use small feet on the bottom of
appliance to set the appliance top
surface level with other surfaces.
13.4 Anti-tilt protection
Adjust the appliance to the correct
height and put it in the correct area
before you attach the anti-tilt protection.
CAUTION!
Install the anti-tilt protection
to prevent the appliance
from falling under incorrect
loads. The anti-tilt
protection only works when
the appliance is put in a
correct area.
The anti-tilt protection has two parts (A +
B). You can find the anti-tilt protection (B)
on the right or left side of the rear wall of
the appliance.
1. Install the anti-tilt protection (A) on
the wall.
Make sure that the wall is made of a
solid material. If not, you need to
make the wall sufficiently strong to
hold the weight.
2. Put the appliance in the middle of
3. Install the anti-tilt protection (A)
4. Check that the anti-tilt protection (A)

13.5 Electrical installation

This appliance is supplied without a main
plug or a main cable.
13.6 Covering terminal board
B
• The recommended cross-section area
• When you refit the mains terminal
Make sure that the surface behind
the appliance is smooth.
the space between the cupboards.
If the space is larger than the width
of the appliance, you must adjust the
side measurement.
approximately 77 mm below the top
surface of the appliance and 50 mm
from the left or right side of the
appliance into the circular hole on
the bracket. Screw it into the wall.
fits minimum 20 mm into the hole in
the rear wall of the appliance (B)
when you push the appliance.
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
is six square millimetres (6 mm²).
cover, make sure that the lower tabs
are located inside the bottom edge of
50 mm
77 mm
A