AEG 41102IU-MN User Manual page 26

26 www.aeg.com
Problem
You cannot activate the ap-
pliance.
You cannot activate or oper-
ate the hob.
You cannot activate or oper-
ate the hob.
You cannot activate or oper-
ate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
Residual heat indicator does
not come on.
The heat setting changes
between two levels.
The sensor fields become
hot.
comes on the hob dis-
play.
comes on the hob dis-
play.
comes on the hob dis-
play.
comes on the hob dis-
play.
comes on the hob dis-
play.
The oven does not heat up.
The oven does not heat up.
Possible cause
The fuse is blown.
You touched 2 or more sen-
sor fields at the same time.
STOP+GO function oper-
ates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
The zone is not hot because
it operated only for a short
time.
Power management function
operates.
The cookware is too large or
you put it too near to the
controls.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on the
zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
The oven is deactivated.
The clock is not set.
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Touch only one sensor field.
Refer to "Hob - Daily use"
chapter.
Clean the control panel.
Remove the object from the
sensor fields.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Refer to "Hob - Daily use"
chapter.
Put large cookware on the
rear zones if possible.
Deactivate the hob and acti-
vate it again.
Refer to "Hob - Daily use"
chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hob - Hints and
tips" chapter.
Use cookware with correct
dimensions.
Refer to "Hob - Hints and
tips" chapter.
Activate the oven.
Set the clock.