Argon 18 E-117 TRI+ Assembly Manual page 32

E-117 TRI+: 15. Tailwind Installation
(5Nm)
1. Saddle clamp
Slide carrier into seat post as desired saddle po-
sition. Tighten saddle into carrier with M5 bolts
(provided with Ritchey's saddle clamp) at 5 Nm.
Note correct carrier orientation.
2.2. TW orientation
2. Tailwind (TW) slide post
Ensure slide post's top is facing up (see above).
Ensure slide post does not extend further than
minimum insertion mark.
24°
-5°
2.3. TW slide post
Range of adjustment: 24°/-5°
2.1. TW slide post
With TW box removed from hub, slightly
tighten M5x110mm screw. Ensure all
components are sandwiched as shown above.
(3Nm)
(3Nm)
(4Nm)
2.4. TW slide post
Without the M5 bolt being torqued,
position TW as wanted. Torque bolt to 4Nm.
31