Argon 18 E-117 TRI+ Assembly Manual page 14

E-117 TRI+: 8. Headset Installation
STEP
1
First, you must assess which
25mm, 15mm or 0mm.
STEP
2
Inspect the bike's head tube for any sharp edges and
apply a small amount of grease.
For the 25mm and 15mm setups, lightly grease the
STEP
3
bottom section of the 3D bearing holder (6) and insert
the plastic sleeve (7).
Position the headset inside the head tube. Place
the top 3D assembly with the headset bearing inside
(this will prevent the sleeve from getting damaged).
Add the compression ring (4) on top of the bearing,
STEP
then add the press t 3D system tool and softly press
4
down the assembly until it bottoms out using a Bearing
Cup Press (Park Tool HHP-2). Then, insert the bottom
bearing (5), micro spacers (3) and top cap (2), slide the
fork and stem and measure the steerer length needed.
For the 0mm setup , do not use the plastic sleeve.
Install the 3D bearing holder (6) with grease applied
directly inside the frame.
To remove the 3D bearing holder, insert the Park Tool
RT-1 and then tap it carefully until the spacer comes out.
setup
25mm
setup suits your needs:
1
3
4
5
head tube
(bike)
5
setup
15mm
1
2
2
3
4
5
6
6
7 7
head tube
(bike)
5
Compressor
1
2 Top cap
3 Micro spacers
setup
4 Compression ring
0mm
Bearing
5
3D bearing holder
6
Plastic sleeve (no need for 0mm setup)
7
Top cap for 0mm setup
1 8
8
3
4
5
6
head tube
(bike)
5
13