Table of Contents
Advertisement
USB Ports
USB 4
USB 3
USB 3.0
USB 2
USB 1
USB 3.0
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with four onboard USB 3.0 ports (USB 1-2/3-4). The 10-pin
connectors allow you to connect 4 additional USB 2.0 ports (USB 5-6/7-8). The additional USB
ports may be mounted on a card-edge bracket. Install the card-edge bracket to an available
slot at the rear of the system chassis and then insert the USB port cables to a connector.
BIOS Setting
Configure these onboard USB devices in the Advanced menu ("USB Configuration" submenu)
of the BIOS. Refer to the chapter 3 for more information.
Driver Installation
You may need to install the proper drivers in your system operation to use the USB device.
Refer to your operating system's manual or documentation for more information.
Chapter 2 Hardware Installation
Chapter 2
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S3 (STR - Suspend To RAM) state.
USB 7-8
USB 5-6
USB 2.0
9
10
Key
N. C.
GND
GND
+Data0
+Data1
-Data1
-Data0
VCC
VCC
2
1
20
Important:
If you are using the Wake-On-USB Keyboard/Mouse function for 2 USB ports, the
+5V_standby power source of your power supply must support ≥1.5A. For 3 or more
USB ports, the +5V_standby power source of your power supply must support ≥2A.
www.dfi.com
Advertisement
Table of Contents
