DFI SD101 User Manual page 34

SATA Configuration
This section is designed to select the SATA controller and the type of hard disk drive which are
insalled in your system unit.
InsydeH20 Setup Utility
Advanced
SATA Controller(s)
SATA Mode Selection
Serial ATA Port 0 [Not Installed]
Port 0
Serial ATA Port 1 [Not Installed]
Port 1
Serial ATA Port 2 [Not Installed]
Port 2
Serial ATA Port 3 [Not Installed]
Port 3
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter
SATA Controller(s)
This field is used to enable or disable Serial ATA devices.
SATA Mode Selection
The mode selection determines how the SATA controller(s) operates.
AHCI Mode
This option allows the Serial ATA devices to use AHCI (Advanced Host Controller Inter-
face).
Serial ATA Port 0, 1, 2, and 3
This field is used to enable or disable the serial ATA port.
Chapter 3 BIOS Setup
Rev. 5.0
Enable/Disable SATA
<Enabled>
Device.
<AHCI>
<Enabled>
<Enabled>
<Enabled>
<Enabled>
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Chapter 3
USB Configuration
This section is used to configure the parameters of the USB device.
Advanced
USB BIOS Support
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
USB BIOS Support
Disabled
Disable USB keyboard/mouse/storage support.
Enabled
Enable USB keyboard/mouse/storage support under UEFI and DOS environment.
34
InsydeH20 Setup Utility Rev. 5.0
USB keyboard/mouse/stor-
<Enabled>
age support under UEFI
environment.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi.com