I/O Connectors; Sata (Serial Ata) Connectors; Sata (Serial Ata) Power Connectors - DFI SD101 User Manual

I/O Connectors

SATA (Serial ATA) Connectors

Features
• 2 Serial ATA 3.0 ports with data transfer rate up to 6Gb/s (SATA 0 and SATA 3)
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Se-
rial ATA data cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu ("SATA Configuration" submenu) of the
BIOS. Refer to the chapter 3 for more information.
Note:
Some 3rd party SATA Gen 2 speed device controllers used on the system board
paired with the Intel 100 Series chipset are intermittently detected. Before using SSD
®
devices or mSATA SSD devices, please check whether the device and the cable which
are used on the system board conform to Intel's official regulations.
Chapter 2 Hardware Installation
Chapter 2

SATA (Serial ATA) Power Connectors

1 GND
TXP
TXN
GND
RXN
RXP
7
GND
SATA 3.0 6Gb/s
SATA 0
SATA 3
These SATA power connectors supply power to the SATA drive. Connect one end of the pro-
vided power cable to the SATA power connector and the other end to your storage device.
21
SATA
Power
+12V
1
Ground
Ground
4
+5V
www.dfi.com