Rear Panel I/O Ports; Dc-In (Sd101)/15~36V Dc-In (Sd103) - DFI SD101 User Manual

Rear Panel I/O Ports

DC-in
DVI-I
HDMI
The rear panel I/O ports consist of the following:
• 1 DVI-I (DVI-D signal)
• 2 RJ45 LAN ports
• 4 USB 3.0 ports
• 1 HDMI/DP (DP available upon request)
• 1 DC-in
Chapter 2 Hardware Installation
Chapter 2
USB 3.0
LAN 1 LAN 2
12V DC-in (SD101)/15~36V DC-in (SD103)
DC-in
This jack is considered a low power solution. Connect a DC power cord to this jack. Using a
voltage more than the recommended range may fail to boot the system or cause damage to
the system board.
The DC-in jack on the system board co-lays with a 4-pin right angle connector (optional) or
4-pin vertical type connector (optional) as the photo displayed below.
4-pin Right Angle
(optional)
18
4-pin Vertical Type (optional)
DC-in (default)
www.dfi.com