Cpu - DFI SD101 User Manual

5. Grasping the module by its edges, align the module into the socket at an approximately 30
degrees angle. Apply firm even pressure to each end of the module until it slips down into
the socket. The contact fingers on the edge of the module will almost completely disappear
inside the socket.
6. Push down the module until the clips at each end of the socket lock into position. You will
hear a distinctive "click", indicating the module is correctly locked into position.
Clip
Important:
When installing one DDR4 SODIMM only, make sure to install it into the SODIMM 1
socket.
Chapter 2 Hardware Installation
Chapter 2

CPU

The system board is equipped with a surface mount LGA 1151 socket. This socket is exclu-
sively designed for installing a LGA 1151 packaged Intel CPU.
Important:
1. Before you proceed, make sure (1) the LGA 1151 socket comes with a protective
cap, (2) the cap is not damaged and (3) the socket's contact pins are not bent. If
the cap is missing or the cap and/or contact pins are damaged, contact your dealer
immediately.
2. Make sure to keep the protective cap. RMA requests will be accepted and pro-
cessed only if the LGA 1151 socket comes with the protective cap.
Note:
Clip
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
11
Protective
cap
www.dfi.com