Rj45 Lan Ports; Graphics Interfaces - DFI SD101 User Manual

RJ45 LAN Ports

LAN 1 LAN 2
LAN 1
LAN 2
Features
• Intel I211AT PCI Express Gigabit Ethernet controller
®
• Intel I219V PCI Express Gigabit Ethernet Phy
®
The two LAN ports allow the system board to connect to a local area network by means of a
network hub.
BIOS Setting
Configure the onboard LAN ports in the Advanced menu ("ACPI Settings" submenu) of the
BIOS. Refer to the chapter 3 for more information.
Driver Installation
Install the LAN drivers. Refer to the chapter 4 for more information.
Chapter 2 Hardware Installation
Chapter 2

Graphics Interfaces

The display ports consist of the following:
• 1 HDMI port
• 1 DVI-D port
DVI-D
HDMI
DVI-D Port
The DVI-I port is used to connect an LCD monitor. This port supports DVI-D signal only.
Connect the display device's cable connector to the DVI-I port. After plugging the cable con-
nector into the port, gently tighten the cable screws to hold the connector in place.
HDMI Port
The HDMI port which carries both digital audio and video signals is used to connect a LCD
monitor or digital TV that has the HDMI port.
BIOS Setting
Configure the display devices in the Advanced menu ("Video Configuration" submenu) of the
BIOS. Refer to the chapter 3 for more information.
Driver Installation
Install the graphics driver. Refer to chapter 4 for more information.
19
www.dfi.com