Setting The Clock; Setting The Total Kilometres; Switch From Bike 1 To Bike - VDO X1DW Instruction Manual

GB SLO PL JP
BIKE 1 ...SET SIZE/CONTINUE
Now set the wheel roll circum-
ference measured using
Confirm the entry with M .
BIKE 1/SET OK? Confirm with M .
The display confirms: WHEELSIZE/SET DONE.
Automatic return to SETTINGS/SELECT.

5.3 Setting the clock

How to set the clock:
Using go to SETTINGS/
SELECT. Confirm with M .
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode)
Using go to CLOCK/SET.
Confirm with M .
CLOCK/24-H-MODE (you can
switch to 12-H mode using
Confirm with .
M
14 X1DW
Attention: The factory settings for bike 1 = 2155
mm and for bike 2 = 2000 mm. If you do not enter
. any wheel sizes, the computer works with these
factory settings. The values measured in this
way for speed, distance etc. can differ widely
from the actual values.
CLOCK...SET HOUR/CONTINUE
Set the hours using
Confirm the hour setting
with M .
CLOCK...SET MINUTES/
CONTINUE. Set the minutes
using . Confirm the
minutes setting with
CLOCK/SET OK? Confirm with M .
The display confirms: CLOCK/SET DONE.
. Automatic return to SETTINGS/SELECT.
VDO CYCLECOMPUTING

5.4 Setting the total kilometres

You can program the values on the distance coun-
ter at any time (e.g. at the end of a season).
Using
SELECT. Confirm with
You are now in setting mode
(pressing
you back to function mode).
Using
SET. Confirm with
.

5.5 Switch from bike 1 to bike 2

Your VDO computer can be used on 2 bikes.
If you switch from bike 1 to bike 2, the computer
recognises the transmitter from bike 2. The
computer then automatically switches to bike 2.
M . All data are now saved for bike 2. When you use
the computer again on bike 1, transmitter 1 is
recognised. The computer switches to bike 1.
The data are now saved for bike 1.
www.vdocyclecomputing.com
go to SETTINGS/
M .
C for 3 seconds gets
go to ODOMETER/
M . ODO BIKE 1/SET OK? Confirm with
The display confirms ODO BIKE 1/SET DONE.
Automatic return to SETTINGS/SELECT.
Note: The transmitter on bike 2 must have been
set to bike 2 before using it the first time.
JP PL SLO GB
ODOMETER/ODO BIKE 1
(use to go to setting for
BIKE 2). Confirm with M .
ODO BIKE 1 ...SET DISTANCE/
CONTINUE.
You can set the flashing digits
using . To access the next
digit, confirm with M .
Repeat the steps until the last
digit on the right is flashing.
Confirm with .
M
M .
>>> P03
The selected Bike 1 or 2 is shown
on the display bottom left ( ).
>>> P03
X1DW 15