Lexmark X746de Service Manual page 92

7526
Step Questions / actions
1. Remove the right cover. See
2
cover removal" on page
2. Check the cartridge motor 1/fuser motor
cable for proper connection to the EP
drive assembly, for pinch points for the
cable, and for cable or connector damage.
Is either cable damaged?
Replace the cartridge motor1/fuser motor
3
cable. See
"Cartridge motor 1/fuser cable
removal" on page
Note: Make sure to check the replacement
cable first before installation, leaving the
original cable in place. Make sure to verify if
the new cable is working properly. If new
cable does not correct problem, do not install
it.
Did the error clear?
Measure the continuity across all of the fuses
4
on the system board.
Are any of the fuses blown?
1. Plug the cartridge motor1/fuser motor
5
cable to a new EP drive assembly.
2. Bring the printer up in Diagnostics Menu
(Turn off the printer, press and hold
buttons 3 and 6, then turn on the printer).
3. Touch MOTOR TESTS.
4. Touch Tray 1.
Did the error clear?
Service Manual
2-52
"Right
4-38.
4-54.
Yes
Go to step 3.
Problem solved
Replace the system board.
See
"System board
removal" on page 4-157.
Replace the EP drive
assembly. See
"Electrophotographic
(EP) drive assembly
removal" on page 4-78.
No
Go to step 4.
Go to step 4.
Go to step 5.
replace the system board.
See
"System board
removal" on page 4-157.
Previous
Next
Go Back