Lexmark X746de Service Manual page 74

7526
Error code
245.02
245.03
245.05
245.10
245.11
245.17
Service Manual
2-34
Description
Tray 5 pass thru sensor made at
POR.
Possible causes:
• Paper jam leaving a page over the
sensor
• Defective pass thru sensor
Pick timeout from tray 5 exceeded
without a tray sensor break.
Possible causes:
• Tray 5 incorrect media setting
• Tray 5 incorrect paper loaded
• Tray 5 incorrect media restraint
setting
• Tray 5 assembly failure
• Aligner failure
• Transport belt module failure
Possible causes:
• Incorrect media setting
• Incorrect paper loading
• Incorrect media restraint setting
• Tray 5 paper pick mechanism
• Loading card stock from the
special media tray above the fill
line
Tray 5 page exits pass thru sensor
broken early.
Possible causes:
• Defective pass thru sensor
• Faulty cable in connector JOPT1
on the system board
Tray 5 sensor never broke.
Possible causes:
• Incorrect tray 5 media setting
• Incorrect tray 5 paper loading
• Incorrect media restraint setting
• Paper tray failure
• Aligner failure
• Transport belt module failure
• Loading card stock from the
special media tray above the fill
line
• High humidity (replace paper)
Tray 5 detected a jam from idle.
Possible causes:
• Paper jam leaves a page over the
sensor
• Defective input sensor
• Faulty system board
Action
• Check for anything in the paper path that might
cause the media to jam.
• If the problem persists, go to
Jam service check" on page
• Remove all media present in the paper path.
• Make sure proper media is set for the type of
paper used in tray 5.
• Fan the media, and stack flat in tray 5.
• Properly set the media restraints in tray 5.
• If the problem persists, go to
Paper Jam service check" on page
• Ensure proper media is set for the type of paper
used in tray 5.
• Fan media, and stack flat in tray 5.
• Properly set the media restraints in tray 5.
• Check the pick tires in tray 5 and replace if worn.
• If the problem persists, go to
Jam service check" on page
• Make sure the proper media is set for the type of
paper used in tray 5.
• Check for anything in the paper path that might
cause the paper to Jam.
• The exits pass thru sensor may not be
functioning properly. Go to
Jam service check" on page
• Ensure the proper media is set for the type of
paper used in tray 5.
• Fan media, and then stack flat in tray 5.
• Properly set the media restraints in tray 5.
• Check the pick tires in tray 5 and replace if worn.
• If the problem persists, go to
Paper Jam service check" on page
• Clear away anything in the paper path that might
cause the paper to jam.
• If the problem persists, go to
Jam service check" on page
"245.02—Paper
2-95.
"245.03, 245.11—
2-96.
"245.05—Paper
2-96.
"245.10—Paper
2-97.
"245.03, 245.11—
2-96.
"245.17—Paper
2-98.
Previous
Next
Go Back