Lexmark X746de Service Manual page 72

7526
Error code
244.03
244.05
244.10
244.11
244.17
Service Manual
2-32
Description
Pick timeout from tray 4 was
exceeded without a tray 4 sensor
break.
Possible causes:
• Tray 4 incorrect media setting
• Tray 4 incorrect paper loading
• Tray 4 incorrect media restraint
setting
• Tray 4 assembly failure
• Aligner failure
• Transport belt module failure
Tray 4 picked, but page failed to reach
the option sensor in time.
Possible causes:
• Tray 4 incorrect media setting
• Tray 4 incorrect paper loading
• Tray 4 incorrect media restraint
setting
• Tray 4 paper pick mechanism
assembly failure
• Loading card stock from the
special media tray above the fill
line.
Tray 4 page exit pass thru made early.
Possible causes:
• Defective pass thru sensor
• Faulty cable in connector OPT1
Tray 4 sensor never broke.
Possible causes:
• Incorrect tray 4 media setting
• Incorrect tray 4 paper loading
• Incorrect media restraint setting
• Paper tray failure
• Aligner failure
• Transport belt module failure
• Loading card stock from the
special media tray above the fill
line.
• High humidity (replace paper)
Tray 4 detected a jam from idle.
Possible causes:
• Paper jam leaving page over the
sensor
• defective input sensor
• Faulty system board
Action
• Remove all media present in the paper path.
• Maker sure proper media is set for the type of
paper used in tray 4.
• Fan the media, and stack flat in tray 4.
• Properly set media restraints in tray 4.
• If the problem persists, go to
Paper Jam service check" on page
• Ensure proper media is set for the type of paper
used in tray 4.
• Fan media, and stack flat in tray 4.
• Properly set the media restraints in tray 4.
• Check the pick tires in tray 4 and replace if worn.
• If the problem persists, go to
Jam service check" on page
• Make sure proper media is set for the type of
paper used in tray 4.
• Check for anything in the paper path that might
cause the paper to jam.
• The exit pass thru sensor may not be
functioning properly. Go to
Jam service check" on page
• Ensure the proper media is set for the type of
paper used in tray 4.
• Fan media, and then stack flat in tray 4.
• Properly set the media restraints in tray 4.
• If the problem persists, go to
Paper Jam service check" on page
• Clear away anything in the paper path that might
cause the paper to jam.
• If clearing a paper jam does not fix the problem,
go to
"244.17—Paper Jam service check" on
page 2-93.
"244.03, 244.11—
2-90.
"244.05—Paper
2-91.
"244.10—Paper
2-92.
"244.03, 244.11—
2-90.
Previous
Next
Go Back