Pairing With Low Frequency-Motorola Proximity Pairing (Lf-Mpp) Feature - Motorola APX 6000XE MODEL 2 User Manual

Pairing with Low Frequency-Motorola Proximity Pairing
(LF-MPP) Feature
Ensure that Bluetooth feature of your radio is on and
the Bluetooth tones are enabled.
Bluetooth tones, Bluetooth menu and preprogrammed
buttons must be preprogrammed by a qualified radio
technician. Check with your dealer or system
administrator for more information.
The range of Bluetooth operation is 10 meters line-of-
sight communication. This is an unobstructed path
between the location of the signal transmitter (your
radio) and the location of the receiver (your device or
accessory).
Obstacles that can cause an obstruction in the line-of-
sight include trees, buildings, mountains, cars and
etc.
It is not recommended that you leave your radio
behind and expect your accessory to work with a high
degree of reliability when they are separated.
At the fringe areas of reception, both voice and tone
quality will start to sound "garbled" or "broken". To
correct this problem, simply position the accessory
and radio closer to each other (within the 10 meter
defined range) to re-establish clear audio reception.
Note: Once a COTS headset is paired to your radio, it
is always connected. Therefore the battery life of the
accessory is aligned with the Talk Time power
consumption, not the Standby Time consumption.
Turn on the accessory. Then place it close to your
radio aligning the Bluetooth Pairing Location ( )
on the radio to the Bluetooth Pairing Location (a
blue dot) on the accessory.
If the pairing process is successful, you hear an
incremental-pitched tone. The radio begins to
connect to the device.
If the pairing process fails, you hear a short, low-
pitched tone. The display shows Bluetooth
pairing failed. Repeat this step.
The radio tries to establish connection with the device
once paired.
Note: If the connection fails within 6 seconds, you
hear a decremental-pitched tone to indicate that the
device is unpaired. The display shows <Device
Type> unpaired. Repeat this step to re-initiate the
pairing process.
If the connection is successful, you hear an
incremental-pitched tone. The display shows <Device
115
English