Pro-Form LE TOUR DE FRANCE User Manual page 9

5. Tip: You can attach your own saddle to the
Saddle Carriage (4) if desired. Loosen the
attachment hardware (not shown) beneath the
Saddle (5), and remove the Saddle. Then, attach
your own saddle and retighten the attachment
hardware.
Orient the Saddle Carriage (4) as shown.
Loosen the indicated M8 x 15mm Round Head
Screw (115), and slide the Saddle Carriage (4)
into the Saddle Post (3).
Slide the Saddle Carriage (4) to the desired posi-
tion, and tighten the M8 x 15mm Round Head
Screw (115).
Then, attach an M4 Washer (54) and the
Carriage Cover (91) to the Saddle Carriage (4)
with an M4 x 14mm Screw (117).
6. See step 8. If the Handlebar Clamp (28) and
the four M6 x 16mm Screws (110) are pre-
attached to the Handlebar Carriage (105),
remove them and set them aside until step 8.
Have a second person hold the Handlebar Post
(6) near the Frame (2).
Locate the long wire (C) tie in the Handlebar
Post (6). Tie the lower end of the long wire tie
to the Main Wire (68). Next, locate the same
wire tie in the access hole (D) in the Handlebar
Carriage (105). Pull the wire tie upward until the
end of the Main Wire is in the access hole.
See the inset drawing. Next, pull the upper end
of the long wire tie (C) until the Main Wire (68) is
routed through the Handlebar Carriage (105) as
shown. Then, untie and discard the long wire tie.
Tip: Avoid pinching the Main Wire (68).
Loosen the indicated Adjustment Screw (47),
and insert the Handlebar Post (6) into the
Frame (2).
Move the Handlebar Post (6) upward or
downward to the desired position, and tighten
the Adjustment Screw (47).
5
3
54
91
117
115
6
Avoid pinching the
Main Wire (68)
2
9
5
4
Pull Here
105
C
D
6
C
68
47
68
105
C