Handling Sd Memory Cards; Sd Memory Card Operations - Panasonic AJ-HPX2700G Operating Instructions Manual

Handling SD memory cards

An SD memory card may be inserted or removed, either before or after the power is turned on.
To insert an SD memory card
Open the lid of the switch cover, and insert an SD memory
card (optional) into the SD memory card slot with the notch
upward. Close the lid.
Note
An SD memory card must be inserted with the right side
facing the slot. If the card is hard to insert, it may be
reversed or upside down. Do not force it into the slot. Check
the card before re-inserting it.

SD memory card operations

To format an SD memory card, write settings data or read
data on an SD memory card, navigate the menu to the <SD
CARD READ/WRITE> screen from the FILE page.

Insertion of an SD memory card formatted to a standard
other than the SD and SDHC standards using some other
device will result in the display of "FORMAT ERROR" on the
top right part of the window. In this case, reformat the card
as follows.
Note that the indication "FORMAT ERROR" does not
disappear if the SD memory card is replaced with this menu
page open. When the SD memory card is replaced, perform
TITLE READ.
90
Adjustments and Settings for Recording: Handling data
To remove the SD memory card
Open the lid of the switch cover, and ensure that the busy
lamp is not illuminated. Then, further depress the SD
memory card towards the main unit. This releases the SD
memory card from the insertion slot. Take hold of the SD
memory card and remove it. Close the lid.
When using or storing SD memory cards, be sure to
Avoid high temperature and humid environments
Avoid water
Avoid static electricity
For storage, the SD memory card must be kept inserted into
the unit with the lid closed.
To format an SD memory card
Note
SD memory cards may be formatted via the thumbnail
screen. For more information, see [Formatting SD memory
cards] (page 135).
1
Navigate the menu to the <SD CARD READ/WRITE>
screen.
2
Turn the jog dial button to move the arrow (cursor) to the
menu option CARD CONFIG.
3
Press the jog dial button to display the following
message:
