Connection Of The External Switch - Panasonic AJ-HPX2700G Operating Instructions Manual

Connection of the external switch

It is possible to draw 1.5 A current from the DC OUT
connector of the unit.
Recording start/stop can be controlled by connecting an
external switch to this connector.
Since a tally lamp can be used by connecting an LED to this
connector, it is useful for shooting video when fixing the
camera on a crane.
DC OUT connector
4 1
3 2
LED
Resistance
Max. 50 mA
1: GND
2: TALLY OUT
Open collector output on the unit side.
TALLY ON: Low impedance
TALLY OFF: High impedance
3: Recording start/stop switch
This is connected in parallel to the REC START/STOP button
on the unit or the VTR button on the lens.
4: +12 V
Connector at the cable side
HR10A-7P-4P(73)
(Hirose Denki)
Recording start/stop
Preparation: Connection of the external switch
119