Warning System - Panasonic AJ-HPX2700G Operating Instructions Manual

Warning Description Tables
If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the WARNING
lamp, lamps inside the viewfinder and a warning tone.
Note
The WARNING lamp has the highest priority, followed by the tally lamp, and then the warning tone. When multiple errors
occur simultaneously a higher priority indication will be triggered. The [WIRELESS-RF], however, may not be indicated,
depending on the menu setting.
1. System Errors
Display window
The error code lights up.
indication
WARNING lamp Blinks 4 times per second.
Tally lamp Blinks 4 times per second.
The "SYSTEM ERROR" indication and
Viewfinder
the error code light up.
Warning tone Beeps continuously.
An error in the reference signal or the
Warning description
communication.
Recording/playback
The operation stops.
operation
Please confirm [Error Codes] (page 158)
Countermeasures
and consult your distributor.
2. Card removal error
Display window
Error code "E-30" blinks.
indication
WARNING lamp Blinks 4 times per second.
Tally lamp Blinks 4 times per second.
The "TURN POWER OFF" indicator lights
Viewfinder
up.
Warning tone Continues to beep.
The P2 card being accessed has been
Warning description removed, resulting in an error in the
internal memory of the unit.
Recording/playback
Cannot be performed.
operation
Turn off the power to the unit. If there is
Countermeasures an error in a clip on the removed P2 card,
repair the clip.
3. Battery Empty
Display window All 7 bar indicators for battery remaining
indication capacity start blinking.
WARNING lamp Lights up.
Tally lamp Blinks once per second.
Viewfinder The BATT LED lights up.
Warning tone Beeps continuously.
Warning description The battery has run out.
Recording/playback
The operation stops.
operation
Countermeasures Replace the battery.

Warning System

4. P2 Card Fully Recorded
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning description
Recording/playback
operation
Countermeasures
5. Image Sequence Error (24P, 30P, 25P)
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning description
Recording/playback
operation
Countermeasures
All 7 bar indicators for remaining MEDIA
capacity start blinking.
This lamp will illuminate continuously until
an operation is made after recording.
This lamp will flash 4 times every second
until an operation is made after recording.
The "END" indicator blinks.
When a write protected P2 card has been
inserted, the "WP" indicator lights up.
This tone will sound continuously until an
operation is made after recording.
The P2 cards are recorded to maximum
capacity.
The recording stops.
Delete the clips in the P2 card or insert a
new P2 card.
"E-40" appears in the time code display
field.
Blinks 4 times per second.
Blinks 4 times per second while recording
continues.
The "REC WARNING" indicator lights up.
Beeps 4 times per second while recording
continues.
There are abnormal conditions in the
image sequence of the 24P, 30P, or 25P
mode.
Images can be recorded and played
back, but some frames may be dropped
or the sequences of TC and UB may shift.
Confirm the recording/playback operation
after turning off the power supply once
and then turning it on again. If the error is
not corrected after executing this
procedure, contact the dealer.
Maintenance and Inspections: Warning System
155