Table of Contents
Advertisement
EGR-5000
Quick Start Guide
Section 5:
Device Setup Using PowerPort-E
EGR-5000 Quick Start Guide
When programming the unit through
PowerPort-E, start from an existing or
default parameter file, or create a new
parameter file. To create a new parameter
file, select "Create New Parameter File"
from the "File" pull-down menu as shown
on the left. This will lead to the dialog box
shown below left.
Select the device from the pull-down menu
to load the default parameter file.
A parameter file can also be loaded from a
connected device by selecting "Receive
Data from Device" from the "Device" pull-
down menu.
Effective November 2011
27
Advertisement
Table of Contents
