Dubbing; Dubbing The Contents Of P2 Cards Onto A Tape (Dubbing Mode) - Panasonic AG-HVX200P Operating Instructions Manual

Dubbing

Dubbing the contents of P2 cards onto a tape (dubbing mode)

You can dub any clips from a P2 card to a tape that
you have inserted into the unit.
The recording formats of clips that can be dubbed
are all of the 1080i and 720P formats. In all cases,
the data is recorded in the DV format.
• Check to see if the tape is in a write-protected
state. (During the dubbing operation, an error
message does not appear.)
• Insert the P2 card and tape into the unit, and set
the MEDIA switch to the TAPE position. (Pages
25 and 29)
1
Set the unit's POWER switch to ON.
2
Press the mode button to light up the VCR
lamp.
3
Move the tape forward to the position to
start recording.
• It is convenient to use the End Search (page
74) function.
4
Hold down the mode button (at least 2
seconds).
The DUB lamp now lights, and dubbing mode is
established.
The clips on the P2 card appear as thumbnails
on the LCD screen.
• To set the formats that permit dubbing
1) Press the THUMBNAIL button to close
the thumbnail display, and use the MENU
button to open the menu.
2) Select DUBBING SETUP and then
FORMAT SEL to select the format.
Select the same format as the recording
format shown at the bottom left of the
thumbnail display.
3) Use the MENU button to close the menu,
and press the THUMBNAIL button to return
to the thumbnail display.
Clips with formats that permit dubbing are
indicated by black numbers; all other clips
are indicated by the red numbers. (Clips
indicated by the red numbers cannot be
dubbed.)
86
CAMERA
MCR VCR
PC DUB
• To perform the pulldown setting when
dubbing 720/24PN format clips
1) Press the THUMBNAIL button to close
the thumbnail display, and use the MENU
button to open the menu.
2) Select DUBBING SETUP and then
PULLDOWN SEL. Select 24P or 24PN.
24P: 2:3 pulldown
24PN: 2:3:3:2 pulldown
3) Use the MENU button to close the menu,
and press the THUMBNAIL button to return
to the thumbnail display.
5
Select the fi rst clip to be dubbed using the
and buttons, and press the
You can select multiple clips by repeating
the above procedure. Upon completing the
selection, switch to the SELECTED CLIPS
display on the THUMBNAIL menu, and check
that the cursor appears at the fi rst clip on the
thumbnail display.
• To dub all the clips in the format selected
in step 4
Position the cursor at the fi rst valid clip
(indicated by the black number) on the
thumbnail display.
• Dubbing will start from the clip where the
cursor is positioned so check the position of
the cursor before proceeding.
• Dubbing will not start if the cursor is
positioned on a clip indicated by a red
number.
6
Press the two REC buttons simultaneously.
If you are using the remote control, press the
PLAY button while holding down the REC
button.
Dubbing now starts. When it fi nishes, it will
automatically stop, and the thumbnail display
will be restored. (To stop dubbing while it is
underway, press the
button.
button.)