Table of Contents
Advertisement
Special Features
Before you begin...
* Connect the external Microphone (if used).
* Turn On the Palmcorder.
* Inserta pre-recorded tape to be dubbed.
Audio Dubbing using the
External or Built-in Microphone
The original sound can be replaced with
new sound using the built-in Palmcorder
microphone or an external microphone.
External Microphone
with M3 connector
(not supplied)
External
Microphone Jack
ER
¿ATTE
The AUDIO-REC setting in CAMERA MENU
mode should be as follows:
12 bit The original sound is recorded on ST
(Stereo) 1, and the new sound will be
recorded on ST (Stereo) 2.
16 bit The original sound is replaced with
the new sound.
;
* Select 12 bit if you do not want the original
sound to be completely replaced during an
audio dub.
* |f you dub over a tape which has both 12
bit and 16 bit audio recordings on it, keep
in mind that the original 16 bit audio
portion will be completely replaced.
1 Set POWER to VCR. '
* The POWER lamp lights red.
* Be sure POWER is fully turned to
VCR
position.
2 Press PLAY.
Then press PAUSE where you want
dubbing to begin.
3 Press A.DUB on this unit (for three
seconds) or the remote contro!
(optional, page 74) to put the
Palmcorder in the Audio Dub mode.
* "A.DUB" flashes in the EVF or the
A.DUB
LCD monitor.
^ EE Indication
Button
xl,
—
A-DUB
-
Say
(Continued on next page.)
59
o
Lo)
O
A
LA
TI
D
c
—
c
—
(D
Y
Advertisement
Table of Contents
