Panasonic AG-HVX200P Operating Instructions Manual page 71

P2 card information screen
1 2
1 Write protection mark
2 P2 card status
The amount of memory remaining on the P2
card is displayed using a percentage bar. The
following displays may appear, depending on
the card status.
FORMAT ERROR:
An unformatted P2 card has been inserted.
NOT SUPPORTED:
A card not supported by the unit has been
inserted.
NO CARD:
A card has not been inserted.
3 P2 card remaining memory/total memory
The P2 card's remaining memory and total
memory are displayed here in 1-minute
increments. Fractions of a minute are rounded
off, meaning the display may not match the slot
total.
4 Slot total
The fi gure represents the total remaining
memory of the cards in the two slots. If a P2
card is write-protected, its remaining memory
will not be included in the total remaining
memory.
SD memory card information screen
THUMBNAIL
OPERATION SD STANDARD :
3
USED
PROPERTY
BLANK
META DATA
TOTAL
EXIT
NUMBER OF CLIPS
PROTECT
4
SD STANDARD:
This indicates whether the SD memory card was
formatted in compliance with the SD standard
(SUPPORTED/NOT SUPPORTED).
USED: Space used
BLANK: Space available
TOTAL: Total space
NUMBER OF CLIPS: Number of clips
PROTECT:
This indicates that the SD memory card is write-
protected.
P2
: SUPPORTED
: 96 KB
: 122.3 MB !
: 122.4 MB
:
: OFF
OK
71