Using The Counter; Counter Display (P2 Card / Tape); Memory Stop Mode (Tape); 1394Tc Preset Mode - Panasonic AG-HVX200P Operating Instructions Manual

Using the Counter

Counter display (P2 card / Tape)

You can display a counter that indicates how much
time has elapsed during shooting or playback.
COUNTER button
Camera
BARS SHUTTER
RESET
CH 1 SELECT CH 2 SELECT INPUT 1
INT(L) INT(R) ON
INPUT 1 INPUT 2 OFF
INPUT 2
AUDIO
ZEBRA
COUNTER RESET/TC SET
COUNTER RESET/TC SET button
1
Press the COUNTER button.
Each time you press the button, the display
changes as follows. (Page 90)
0 : 00. 00
Counter value
In the P2 mode, the counter is not displayed
during playback.
M 0 : 00. 00 (Tape only)
Counter value in memory stop mode
TC XX : XX : XX : XX
Time code value
UB XX XX XX XX
User information
FR --- -
Frame rate (30P/24P/24PA) and frame
sequence in progressive mode shooting.
No display:
Data is not displayed.
Resetting the counter
Press the COUNTER RESET button while the
counter is displayed.

Memory stop mode (Tape)

After shooting or playback, the tape can fi rst be
returned to near the pre-programmed position, and
then stopped automatically.
1
Press the COUNTER button to display the
counter in memory stop mode.
2
At the desired position on the tape, press
the COUNTER RESET button to reset the
counter.
58
or Remote control
SPEED SEL
DATE/ PHOTO
OSD TIME SHOT
INPUT 2
ON
OFF
COUNTER RESET TITLE
MIC POWER +48V
MULTI/
P-IN-P REC A.DUB
OIS
/REW PLAY FF/
3
Proceed with playback or shooting.
4
Press the mode button to switch to the VCR
mode. (Page 63)
5
When rewind or fast-forward the tape, it
stops automatically near where you reset
the counter.
START/
STOP During dubbing, reset the counter value at the
OUT point to stop dubbing with memory stop
ZOOM
mode. (Page 81)

1394TC preset mode

When shooting using a multi-camera, you can
synchronously set the initial values of TC.
The camera used for synchronization is the
MASTER and the camera being synchronized is
the SLAVE.
1
Connect a second camera with a 1394 cable
and turn both cameras on.
• For connection (Page 78)
2
Put the MASTER camera in CAMERA mode
and output a video signal from the 1394
terminal.
• Set both cameras to the same recording
format.
Do the remaining steps on the SLAVE camera.
3
Set the SLAVE camera to MCR/VCR mode
and in the setup menus, RECORDING
SETUP screen, set FIRST REC TC to
PRESET mode so the counter shows the
TCG.
• You cannot do this if you have selected
REGEN.
4
In the setup menus, RECORDING SETUP
screen, set 1394 IN PRESET to ON. (Page
108)
• 1394TC appears on the screen.
5
Stop or eject the cassette tape.
6
Press the COUNTER RESET/TC SET button.
The TCG value is preset with the TC value
from the input 1394 signal.
7
Reset the SLAVE camera to CAMERA mode.