Installing and removing the power supply
Installing and removing the battery
Installation
Insert the battery until it clicks into place.
Connecting and disconnecting the power cord
Installation
1
Connect the DC cord to the AC adapter.
2
Plug the AC power supply into the power
outlet.
3
Insert the DC cord's battery connector until
it clicks into place.
DC cord's battery
connector
Removal
1
Set the POWER switch to OFF, and check
that the mode lamp is off.
2
Remove the battery while pressing the
battery release button.
• Support the battery with your hand to ensure
that it will not fall.
Mode lamp
Removal
1
Set the POWER switch to OFF, and check
that the mode lamp is off.
2
Remove the DC cord's battery connector
while pressing the battery release button.
3
Disconnect the AC power supply cord from
the power outlet.
• You cannot charge the battery when supplying
power to the camera-recorder from the AC
adapter.
CAUTION:
• This unit can be operated at a voltage in the
range of 100-240V AC. An AC plug adapter may
be required for voltages other than 120 V AC. If
a conversion plug is required, consult with your
dealer as to which one is to be purchased.
• Disconnect the AC power supply cord from the
power outlet when the unit is not going to be
used.
Battery release
button
17