Basic Shooting Operations (P2 Card); Preparing To Shoot Using A P2 Card; Shooting In Auto Mode - Panasonic AG-HVX200P Operating Instructions Manual

Basic shooting operations (P2 card)

Preparing to shoot using a P2 card

1
Switch the MEDIA switch to "P2".
2
Set the POWER switch to ON. (Page 20)
3
Lift up the viewfi nder and open the card slot
cover.
4
Insert the P2 card securely in the card slot.
• There are two card slots.
• Be absolutely sure to close the card slot
covers to keep the dust out.
4
1
Do not operate the MEDIA switch when the power
is switched ON.
If you attempt to operate the MEDIA switch, the
message "TURN POWER OFF" will be displayed.
In this case, switch OFF the power, and then switch
it ON again.
2
ON
3
Lock
release
P2 TAPE

Shooting in auto mode

1
Turn the POWER switch to ON. (Page 20)
• Check that the mode lamp (CAMERA) is
lighted red. If not, press the mode button.
2
Switch the AUTO/MANUAL switch to AUTO
to select auto mode.
• "A" appears on the viewfi nder and LCD
screens.
• The focus, gain, iris and white balance are
adjusted automatically.
3
Press the START/STOP button (Red) on the
POWER switch to start shooting.
• Press again to return to the camera to the
shooting standby mode.
• Use the handle START/STOP button to make
it easier to shoot from low angles.
2
LCD side
AUTO MANUAL
1
Mode button
CAMERA
MCR VCR
PC DUB
Lock
Mode lamp
release
P2
Handle START/STOP
button
REC CHECK
button
ON
3
25