Advised General Precautions; Installation Conditions And Precautions - HP VMA SAN Installation And Configuration Manual

Regulatory Information
For your protection, this product has been tested for conformance to various national and
international regulations and standards. The scope of this regulatory testing includes electrical and
mechanical safety, electromagnetic emissions, immunity, acoustics and hazardous materials.
Regulatory Model Number
For the purpose of regulatory compliance certifications and identification, this product is assigned
a regulatory model number. This number can be found on the product label, along with the required
approval markings and information. When requesting certification information for this product,
always refer to this regulatory model number.
Do not confuse the regulatory model number with the marketing or model number.
Note:

Advised General Precautions

This section covers a list of highly recommended general precautions:
• Keep the area around the installation clean and free of clutter.
• While working on the system, do not wear loose clothing such as neckties and unbuttoned shirt
sleeves, that can come in contact with electrical circuits or accidentally be pulled into a
cooling fan.
• Remove any jewelry or metal objects from your body before you begin working on a system.
Metal is an excellent conductor and these objects could create short circuits and cause bodily
harm.

Installation Conditions and Precautions

See the installation instructions for your system before connecting this equipment to the input
supply.
The equipment must be provided with a proper AC protective earth (PE) ground connection.
WARNING!
• Know the locations of the power on/off switch on the chassis, as well as the emergency power-
off switch, disconnection switch, or electrical outlet in the room in which the system is
installed. Should an electrical accident occur, this ensures that you can quickly shut off the
power to the system.
• Do not work alone when performing procedures that involve high voltage components.
• Always disconnect the power to a system before removing or installing system components.
Before you disconnect the power, first power down the (operating) system and then unplug
power cords for all power supply modules.
AM456-9025A HP VMA SAN Gateway Installation and Configuration Guide 75