Setting Up Dm Multipath - HP VMA SAN Installation And Configuration Manual

Setting Up DM Multipath

This section shows you how to edit the
multipathd
Multipath default settings are suitable for common multipath configurations.
Setting up DM Multipath includes the following tasks:
Editing the multipath.conf File
1.
Configuring the Multipath Daemon
2.
Editing the multipath.conf File
This section presents the recommended configuration file for
SAN Gateway.
To edit the multipath.conf file, do the following:
AM456-9025A
) then configure the multipath daemon to start when the system boots up. DM
on page 62
HP VMA SAN Gateway Installation and Configuration Guide
multipath.conf
file (the configuration file for
on page 64
multipathd
for use with a HP VMA
65