Verifying Storage Media - HP VMA SAN Installation And Configuration Manual

Enter the following command.
2.
# show license
Output similar to the following appears:
License 1: LK2-VSHARE-XXXX-XXXX-XXXX-XXXX-XXXX-XXXX
Feature:
Valid:
Tied to cluster ID: 99999 (ok)
Active:
License 2: LK2-RESTRICTED_CMDS-XXXX-XXXX-XXXX-XXXX-XXXX-XXXX
Feature:
Valid:
Tied to cluster ID: 99999 (ok)
Active:
If an installed license shows "no" as the Active output, an error may have been made when
Note:
inputting the license key. Double-check the valid license key against the key that is shown in the
show license

Verifying Storage Media

This section demonstrates how to verify the devices that are used by the SAN Gateway. For more
information, see the "Command Line Interface Reference" appendix of the
.
Guide
To verify the devices used by the SAN Gateway, do the following:
Log in to the master node as admin and enter enable mode.
1.
login as: admin
{cluster master} > enable
#
Enter the following command.
2.
# show media
All media devices are shown that can be used by the current VMA Memory Gateway (node or
module) as block storage or caching media. A summary line for each device location is shown,
giving the size and status of that device. Media used by the system for other purposes are not
shown.
32
VSHARE
yes
yes
RESTRICTED_CMDS
yes
yes
output.
HP VMA SAN Gateway Installation and Configuration Guide
SAN Gateway User's
AM456-9025A