Vlan Cluster Interface - HP VMA SAN Installation And Configuration Manual

Log in as admin.
2.
Enter enable mode, and then configure terminal with the following commands.
3.
> enable
# configure terminal
Enable bonding using the following commands:
4.
(config) # network bond eth0 interface eth1 interface eth2 mode balance-rr
(config) # cluster interface eth0
(config) # cluster master interface eth0
(config) # wr mem
Repeat steps 1 through 4 on the secondary node.
5.
Reboot both HP VMA SAN Gateway nodes to reconnect the cluster.
6.

VLAN Cluster Interface

You can hide the cluster multicast traffic using a VLAN for the cluster interface. This requires
changing network settings on your network switch. For information on how to set this up, see the
administration guide for your network switch.
36 HP VMA SAN Gateway Installation and Configuration Guide AM456-9025A