Configuring Fibre Channel Target Ports - HP VMA SAN Installation And Configuration Manual

Every target is a specific port on a hardware Fibre Channel host bus adapter (HBA) installed in the
gateway.
For Fibre Channel, the target ports are present when the HP VMA SAN Gateway boots.
A LUN may be exported through multiple target ports. Active-active multipathing is supported.

Configuring Fibre Channel Target Ports

For Fibre Channel, the target ports are present when the HP VMA SAN Gateway boots, if the HBAs
are installed on the system.
To confirm that the vSHARE system can see the target ports prior to creating the initiator groups,
show targets show targets
use the command. The command enables you to view all target
ports.
show targets Command
show targets
The command lists all of the target ports and their addresses (wwn), filtered by
various options.
Syntax
show targets [node <cluster node id>] [hostname <hostname>]
[protocol fc] [id <target id>] [sessions] [detail]
AM456-9025A HP VMA SAN Gateway Installation and Configuration Guide 53