CHAPTER 4
Prerequisites
AM456-9025A
VMA Gateway Node Replacement
This chapter demonstrates how to replace a HP VMA SAN Gateway node in a
redundant pair, and covers the following topics:
Prerequisites
on page 39
•
Procedure Steps
on page 40
•
Completing the Replacement
•
A typical VMA gateway configuration consists of one or two HP VMA SAN
Gateways, one of which is designated as the master node (mg-b) and one which is
designated as the secondary node (mg-a). For more information on HP VMA Array
redundant pairs, see the
HP VMA SAN Installation and User's Guide
This following naming conventions apply in the replacement procedure:
• mg-a is the node that is being replaced in a redundant gateway pair
• mg-b is the active master node of the redundant gateway pair
HP VMA SAN Gateway Installation and Configuration Guide
on page 41
.
41