Junction Box Installation - Nortel 2330 Installation Manual

Figure 22. Step 10—Locking the Bracket
12 To ensure that the AP is fully locked onto the bracket, gently pull down on the access point and attempt to
rotate it from side to side.
If the access point comes off the bracket, relock the device onto the bracket as described in
page 43.
13 If the other end of the Cat-5 cable (ferrite beaded for AP-2330) is not already connected and the link
activated, then go to
on page 58.

Junction box installation

(For required mounting hardware and tools, see
1
Unlock the universal mounting bracket from the AP by inserting the 3-mm or 1/8-inch screwdriver into
the Unlock hole on the AP as shown in
Caution!
components, do not use excessive force when inserting a tool into the Unlock or
Lock hole.
Installing and connecting an AP-2330/2330A/2330B 49
Lock
T-bar
"Connecting an AP to a WSS" on page
Table 3 on page
Figure
To avoid damage to the AP's lock mechanism or electronic
Nortel WLAN Access Point 2330/2330A/2330B Installation Guide
56. Otherwise, go to
39.)
23.
step 11 on
"Verifying AP health"