Nortel 2330 Installation Manual page 42

42 Installing and connecting an AP-2330/2330A/2330B
Figure 10. Step 6—Removing the Bracket
7
Install the universal mounting bracket as follows onto the T-bar or T-bar clamp:
a
As shown in
two screw holes face downward and the two T-bar flanges face upward and are adjacent to the T-bar
edges.
Figure 11. Step 7—Top View
Universal mounting
bracket
T-bar
Port connector
opening
(Viewed from above ceiling tiles, looking down.)
b
Properly align the bracket for mounting by placing the bracket so that its port connector opening is
to the left of the hole you cut for the cables.
c
Rotate the universal mounting bracket clockwise until the flanges snap into place on the T-bar or
clamp as shown in
NN47250-302 (320661-E Version 02.01)
Figure 11, place the universal mounting bracket against the T-bar or clamp so that the
Figure 12 on page 43.