Nortel 2330 Installation Manual page 45

3
Install the T-bar clamp that fits the T-bar:
a
Slide each half of the clamp onto the T-bar so that the clamp lip is fully on the T-bar.
b
Slide the two halves of the clamp toward each other until the tabs are inserted completely into the
holes and the clamp fits snugly on the T-bar.
Figure 15
15.9-mm (5/8-inch) T-bar.
Figure 15. Step 3—Installing the T-bar Clamp for a 23.9-mm (15/16-inch)
T-bar
T-bar
Figure 16. Step 3—Installing the T-bar Clamp for a 15.9-mm (5/8-inch)
T-bar
T-bar
shows an example for a 23.9-mm (15/16-inch) T-bar.
T-bar clamp halves
T-bar clamp halves
Nortel WLAN Access Point 2330/2330A/2330B Installation Guide
Installing and connecting an AP-2330/2330A/2330B 45
Slide together
Slide together
Figure 16 shows an example for a