Radio Frequency Exposure; Additional Radio Safety Advisories; Cable Requirements - Nortel 2330 Installation Manual

36 Installing and connecting an AP-2330/2330A/2330B

Radio Frequency Exposure

Federal Communications Commission (FCC) Docket 96-8 for Spread Spectrum Transmitters specifies a safety standard
for human exposure to radio frequency electromagnetic energy emitted by FCC-certified equipment. Nortel AP-2330/
2330A/2330B products meet the uncontrolled environmental limits found in OET-65 and ANSI C95.1-1991, if proper
installation procedures are followed. To ensure compliance with these exposure requirements, this device must be
installed in such a manner as to maintain a minimum of 20 cm separation distance between the radiating element(s) and
all persons.

Additional radio safety advisories

(For translations of these warnings, see
Warning!
inches) separation distance between the radiating element(s) and all persons. This safety
warning conforms with FCC radio frequency exposure limits.
Warning!
explosive environment unless the device has been modified for such use by qualified
personnel.
Warning!
receiving.
Warning!
codes, national codes, and safety directors of the location for usage constraints.

Cable requirements

Note.
The AP-2330/2330A/2330B is intended for indoor use only. Do not install the
device nor operate it outdoors.
Note.
To reduce the possibility of connection interference caused by dust, clean the
Cat-5 connector pins before inserting a cable into an AP.
NN47250-302 (320661-E Version 02.01)
"Radio safety warnings" on page
Install this device in such a manner as to maintain a minimum of 20 cm (7.9
Do not operate the AP near unshielded blasting caps or in an otherwise
Do not touch or move the AP when the antennas are transmitting or
Before using a wireless device in a hazardous location, consult the local
118.)