Suspended Ceiling Installation-Flush Ceiling Tiles - Nortel 2330 Installation Manual

40 Installing and connecting an AP-2330/2330A/2330B
Figure 7. Universal Mounting Bracket
Screw holes
Suspended ceiling installation—flush ceiling tiles
(For required mounting hardware and tools, see
1
Select an installation location that is centered over a T-bar in the ceiling.
2
Cut a hole as follows in the ceiling tile for the Cat-5 cable (ferrite beaded for AP-2330):
a
Place the mounting template over the area where you plan to install the AP.
b
Use the box cutter to cut along the line marking the opening for the port connector.
c
Remove the mounting template and the material you cut from the ceiling panel.
3
Determine whether to install a T-bar clamp onto the ceiling T-bar:
• If the T-bar width is 14.2 mm (9/16 inches), you need to install the 14.2-mm (9/16-inch) T-bar
clamp. Go to
• If the T-bar width is 23.9 mm (15/16 inches), the universal mounting bracket fits directly onto the
T-bar. Go to
4
Install the 14.2-mm (9/16-inch) T-bar clamp onto the ceiling T-bar as shown in
a
Slide each half of the clamp onto the T-bar so that the clamp lip is fully on the T-bar.
b
Slide the two halves of the clamp toward each other until the tabs are inserted completely into the
holes and the clamp fits snugly on the T-bar.
NN47250-302 (320661-E Version 02.01)
T-bar flanges
Table 3 on page
step 4.
step 5.
Port connector
opening
39.)
Figure 8 on page 41.